Skip to content

Free gutter consultation, just pick up the phone: (843) 751-4238

(843) 751-4238

ServicesGutter Covers

Charleston Gutter Covers

A gutter cover is a solid lid fitted across the top of the gutter. Rainwater wraps over its rounded front and falls inside, while leaves and needles slide away. We fit them to your current gutters so those gutters last longer and ask less of you.

Worker on a ladder pressing a brown curved aluminum cover onto a white gutter beneath asphalt shingles on a brick house

What a Gutter Cover Does

Most covers work on surface tension. Water follows the rounded nose of the cover and runs down into a slot behind it. Debris is too light and too dry to make that turn, so it falls to the ground. Since the top is solid, needles can't poke through and sit there the way they do in some screens.

Covers are a different tool than gutter guards. Guards are mesh or perforated screens that catch debris on top. Covers shed it. If your roof drops pine straw, oak tassels or magnolia leaves, a solid cover is often the better fit. If you get mostly fine grit off the shingles, a guard may be the smarter buy, and we'll tell you so.

We think of covers as upkeep. A gutter that stays empty doesn't hold standing water, doesn't sag under wet leaves and doesn't rust from the inside. That adds years to the gutters you already paid for.

What a Cover Job Includes

Checking the gutters underneath

A cover is only as good as the gutter below it. Before we fit anything, we look over hangers, seams, end caps and slope. Any section that needs work gets called out and priced separately in writing as gutter repair.

Sized to your gutter

We measure the width and profile of your gutter so each cover lies flat. A poor fit leaves a gap at the back or a lift at the front, and debris works its way in there.

Fastened to stay put

Every piece fastens to the gutter's front lip, then either slips beneath the bottom row of shingles or attaches to the fascia, based on your roof. We lift shingles only as much as we must and never nail through them.

Careful corners and ends

Corners, inside and outside, are the usual weak point for covers. We cut and overlap them so water still follows the bend and no gap opens as the metal expands and shrinks with the heat.

Tidy yard and a final walk

We collect scraps and screws from your lawn and beds. After that, we go around the house with you and point out where each piece went.

Signs Gutter Covers Make Sense for Your Home

  • Gutters fill up between seasons

    If your gutters are packed again a few months after they were emptied, the trees are winning. A cover stops that cycle.

  • Pine needles in the screens

    Needles slip through mesh and stand up like bristles. Once they mat together, the screen becomes a lid. Solid covers don't have that problem.

  • Water spilling over the front

    Overflow in a hard storm often means a clog farther down the run. It soaks the ground at your foundation and stains the siding below.

  • Plants or mosquitoes in the gutter

    Seedlings and still water mean the gutter is holding organic matter. In our long, humid summers that wet mat breeds bugs and eats at the metal.

  • You'd rather stay off the ladder

    A cover won't make gutters zero-maintenance. It does cut way back on how often anyone needs to climb up there.

The Steps of a Cover Job

  1. 1

    A call to start

    Describe your home, the trees around it and what you notice during storms. We'll schedule a visit to see it.

  2. 2

    A visit and a written price

    We measure each run, look over the gutters and check the roof edge. Your written estimate breaks out every item, along with photos of anything that should be fixed first.

  3. 3

    The install

    Most houses are done in a day or less. A cover needs an empty, solid trough under it, so we check each run, then fit and fasten the covers and finish off the corners.

  4. 4

    Hose test and final look

    We run a hose across the roof to confirm water drops into the gutter and drains out the right spot. Then we tidy up and review the work with you.

What Sets the Price of Gutter Covers

The cost of covers depends mostly on how many feet of gutter you have, how easy they are to reach and which cover you pick. We quote only after seeing the house, and each part of the job is listed so nothing pops up later.

Feet of gutter
Longer runs take more material and more hours. Covering a plain ranch costs less than a home with many short pieces.
Height and slope of the roof
Second-story walls and steep roofs call for more setup and slower ladder work, which adds labor.
What the cover is made of
Aluminum covers are the usual choice and wear well. Thicker gauges and salt-resistant finishes cost more but often last longer close to the water.
Shape of your gutters
Loose hangers, leaking seams or a bad slope need fixing before any cover goes on. We price that work on a separate line so you can see it.
Corners and roof features
Valleys that pour water into one place and many inside corners need more cutting and fitting.

Gutter Cover Questions

Something not covered here? (843) 751-4238

Will gutter covers handle a heavy summer downpour?

In most storms, yes. In the hardest bursts, some water can shoot past the nose of a cover, especially below a roof valley. We look for those spots during the estimate and set the cover to handle them as well as it can.

Do I ever need to touch the gutters again?

Less often, but not never. Fine grit from shingles and pollen can still settle in the trough over time. We suggest a look once a year so small things get caught early.

Can you put covers on my existing gutters?

Usually. If the gutters are in decent shape, covers go right on top. If they're rusted through or pulling away, we'll be straight with you that gutter installation makes more sense than covering a failing system.

Covers or guards: which is better?

It depends on what falls on your roof. Covers do best with leaves and pine needles. Guards can be better for fine debris and lower-pitch roofs. We'll tell you which one fits after we see your trees and roofline.

Will installing covers damage my roof?

It shouldn't. We lift shingles only as far as needed, and on many roofs we mount to the fascia instead. If your shingles are brittle, we'll point that out before we start.

White seamless gutter along the eave of a brick ranch house, with a white downspout running down near the garage corner to a splash block in a mulched bed.

Keep Your Gutters Working Longer

Tell us about your house and your trees. We'll come out, look at the gutters and give you a written estimate for covers that fit.